Draper 89713 Plasterer's Feather Edge,1.2 m x 100 mm

Product Information

When am I supposed to apply the feather edge? (how soft should the render be? completely fresh and wet? slightly firm to touch? etc) Most often these bumps etc are not very big at all but it really makes a difference to the finished job.

Feathering out with some filler will allow you to create a surface which will appear flatter even if it is not. By tapering the bumps and hollows out, the light will have no edges to reflect off and it will appear flat to the eye. If you are attempting to feather out with filler, use some All-Purpose filler which can be pre or ready mixed. This will help you feather out well as the filler will be of the same consistency every time you use it. Anything ad-hoc or out of the ordinary we are keen to help and our Managing director Phil Hall an avid inventor loves to solve tool based problems so lets give him a challenge!

Feathers get less dense along their length Feather Edged Boards Used for Fencing and Garden Buildings Uk leading company in Plastering Tools, Screeding Tools, Levelling Tools and all related Construction Tools! Please note, it does not very often make the chip invisible and some fine surface filler can be placed into the chip to be smoothed out with a paint scraper.

By making sure the underside of the bow (the concave surface) faces the building, the bottom edge hugs the board beneath it really tightly when the board is fixed. This stops and water blowing up underneath the boards.

To get rid of any surface bumps or lumps and finish with a totally flat surface, the chances are you will have to chisel off the lump and make good the hole with some filler. Use tapered or feathered edge plasterboard for dry lining Materials Used for Feathering out Plaster, Filler or Dry Wall You can see a caulking blade being used with an ideal feathering out material called Fill and Skim in our video on YouTube. The most obvious application for the DIYer or Home Improver, is in the Feather edged boards used for overlap fencing and panelling. There are really wide blades used for feathering out wider gaps or bumps in walls and these are called caulking blades but for the novice it might be best to use a normal (but wide) scraper and even a plasterers float or trowel.

Sanding down these areas is much better achieved with a Detail sander, Mouse Sander or a Delta Sander. Using differing pressures on the tool will allow you to get the surface looking flat. Be sure to get a sander with a dust bag as the sanding dust gets everywhere. A slight bow in a Feather Edged Board can help it stay watertight Feather Edging Used in Preparing for Decoration Feathering Out Filler

For larger areas that need feathering out, for example when you have inserted a door frame and filled in round the edges which may not then be flush with the existing plaster finish, or where a new section of wall meets and older one, you might want to look at something called Fill and Skim. I battened off the large wall into smaller managable sections, followed the tips on here for preparing the substrate and getting the mix right and found it went on well (thanks everyone). I can get the wall looking pretty decent with just my trowel, but obviouly still need to remove the odd high spot and fill in the low spots. Dry lining however is usually done on the same type of stud wall but this time the boards are not plastered, they are just painted. Keeping the wall “dry” (apart from the paint of course). How flat and/or smooth should I be trying to get the wall with my trowel before using the feather edge to flatten. As a seasoned plasterer I naturally try to get it as flat as possible with the trowel.