Using the correct screws, tightly secure the number plate in place using the best tool for the job until it is solidly in place. We understand it may be difficult for some people to remove their plates from the holder themselves as they are worried about damaging their plates. But we encourage you to get in touch with us for guidance on how to remove the plate if you are struggling. Will a number plate holder make me fail my MOT? However, the average number plate screw size is 1/4-14-3/4 inches. If this wouldn't fit your vehicle, it's important to have a look at the threading of the screws so that you don't end up damaging the threads, which could be a very costly repair. How Can I Secure My Number Plate?

Only single in colour as two tones are deemed to cause issues when dealing with different light sources and bad weather. Acrylic and gel lettering is still approved, it just needs to be a single tone to be a legal plate. Show plates can, of course, still have more creative designs.

Question about this product?

As well as providing an expansive range of products, there are plenty of other reasons why you should get your private number plate from Absolute Reg.

So do you need a number plate holder? It is completely optional, but in case you are in two minds, let us summarise the benefits of a number plate holder:

Sadly, even though this ritual has been happening since Adam was a pup, there still seems to be no ubiquitous and unintrusive solution for mounting a licence plates which doesn’t risk damaging your duco or ruining the lines and aesthetics of your vehicle. The Clip-It-On Range Looking for an extremely easy solution to discretely securing your number plate to your vehicle with the recognisable honeycomb grille?

Gel number plates can last just as long if not longer than traditional number plates, especially with adequate care and being fortified along with a number plate holder. What are some of the risks of driving solo.? Going Solo is a FREE resource for parents of P-plate drivers. At Absolute Reg, we supply a huge range of personalised number plates for you to choose from. With over 50 million number plates available, search through our full range to find the style and personalisation of your choice. The DVLA have very strict rules about how your number plate should be displayed, and this also applies to number plate screws and fixings. Most jumper cables consist of a pair of conductors just long enough to bridge the gap between two vehicles when parked nose to nose, terminated on each end by pairs of large alligator clips. Short jumper cables start at a length of approximately 2.5-metres, which is basically the minimum length required to bridge the distance between the batteries in two vehicle. Longer lengths are available, allowing greater flexibility in bridging gaps between the stranded and jumper vehicle. Grabbing longer jumper cables is highly advisable for this reason, especially if yours is an offroad vehicle or a mid-engine vehicle like a work van, however they must necessarily be markedly larger in capacity due to the compounding effect of inline resistance as the cable gets longer. Longer jumper cables capable of transferring the same amount of power as a shorter set will inevitably have a larger cross sectional area, and cost significantly more, due to the increased size of the conductors.

Make sure the area is also dry before applying your new number plates, as wet bodywork or water will cause issues with adhesion. Finally, managing our emotions is important. Our emotions fuel our behaviours. Manage emotions in a positive way to maintain a low risk driving attitude. The P drivers project. This project is one of the largest and most complex scientific research studies undertaken in the area of driver education in the world. Once you have successfully drilled your new number plates you will be then be able to fix them to your vehicle. We recommend using our PZ2 Screwdriver Bit which are the correct fitment for the screws.